Panasonic AW-PH500p Operating Instructions Manual - Connections
13
Connections
∫
Connecting the cables to the pan/tilt head
¥
Pan-tilt control connector
The pan/tilt head control cable is connected here.
This connector is connected to the PAN/TILT CONTROL OUT connector on the control panel (AW-RP301, AW-RP501 or
AW-RP505) or multi-port hub (AW-HB505).
For connection, use one of the optional cables listed below.
Pin No.
Signal
Function
1
DI UP
Upward direction control input (contact signal)
2
DI DOWN
Downward direction control input (contact signal)
3
DI LEFT
Leftward direction control input (contact signal)
4
DI RIGHT
Rightward direction control input (contact signal)
5
DO RUN
Rotation underway signal output
6
DI OPT SEL
Power control input
7
DGND
GND
8, 9
NC
Not used
10
HOT2
Data transmitted from pan/tilt head (when controller is used)
11
HOT1
Data transmitted from pan/tilt head (when controller is used)
12
COLD1
Data transmitted from pan/tilt head (when controller is used)
13
COLD2
Data transmitted from pan/tilt head (when controller is used)
16
TXD232
Data transmitted from pan/tilt head (RS-232C)
14
TALLY IN
Tally control input
17
RXD232
Data transmitted from pan/tilt head (RS-232C)
15
DGND
GND
18
DGND
GND
19 - 24
NC
Not used
4
3
2
1
9
8
7
6
5
15
14
13
12
11
10
20
19
18
17
16
24
23
22
21
Pan/tilt head control cable
10 meters: AW-CA24U10
20 meters: AW-CA24U20
30 meters: AW-CA24U30
≥
Contact control signals are not connected to this cable.
The cable can be extended to 500 meters (maximum). To extend the cable, use a commercially available 8-pin modular jack
used for extension purposes, and extend using a 10 BaseT straight cable (UTP category 5).
When using the RS-232C interface to control the pan/tilt head, remove the cable housing of the 10-meter optional cable
mentioned above, and attach a connector which fits the unit used.
Refer to the case where control is exercised using the RS-232C interface.
≥
The brown wire is connected to pin 16.
The red wire is connected to pin 17.
The orange wire is connected to pin 18.
8-pin modular jack
Cable housing