Panasonic CS-E15DB4EW Operating Instructions Manual - How To Operate
E
N
GL
IS
H
HOW TO OPERATE
Timer
1
■
Operation Details
TIMER
• Use the ON timer to turn on the air
conditioner at the desired time. This
will give you a cooling or warming
environment, e.g. when you return
from work or wake up.
• When the ON timer is set, operation
will start maximum 35 minutes
earlier before the actual set time.
• Use the OFF timer to stop the air
conditioner operation at the desired
time. This can save electricity while
you are going out or sleeping.
• The set timer will repeat daily once
it is set.
• If there is a power failure, you can
Select ON or
OFF timer.
AUTO
HEAT
COOL
DRY
OFF
OFF
TIMER
ON
TIMER
FAN
SPEED
2
press the SET button to restore the
previous setting once the power is
resumed.
• If the timer is cancelled, you can
restore the previous setting by
pressing the SET button.
MODE
OFF/ON
FAN SPEED
Set the
desired time.
CHECK
• Where there is error, the unit stops
its operation and timer indicator
POWERFUL
AUTO
blinks.
QUIET
TIMER
TEMP
AIR SWING
MANUAL
3
1. Press for 5 seconds.
1
2
3
ON
SET
Confirm the
TIMER
ON
OFF
CHECK
MANUAL
SET
CANCEL
CLOCK RESET
1
2
3
setting.
CANCEL
Cancel the
selected timer.
OFF
CHECK
CANCEL
CLOCK
RESET
INVERTER
2. Browse for respective error code,
where
“beep” sounds are heard.
3. Turn off the power supply and call
authorized distributor.
Note:
Press the
“RESET” button to quit
checking.
Unit might be operated with limited
function depending on error found.
(Operation starts, 4
“beep” sounds are
heard.
Ensure the clock on the remote control has been set
correctly.
You could use the ON and OFF timers at the same time.
To cancel either the ON or OFF timer, press
or
,
then press
.
Hint
●
Press CLOCK more than 10 seconds to change the time format from 24 hours to AM/PM format.
●
For your convenience, you could set the air conditioner to operate automatically by using both ON and OFF timer.
Troubleshooting
●
TIMER indicator always on.
Timer is activated and the setting will repeat itself daily.
●
POWER indicator is blinking 35 minutes before ON
timer is activated.
The unit is determining the operation mode by sensing the room
temperature. This happens when it has been set to AUTO operation
mode.
7