PlaySafe 22-PS302 Owner's Manual - page 6
6
©2006 Pacific Cycle, Inc.
Support Bar x3
Corner Leg Fitting x2
Center Leg Fitting x1
Pre-Assembled Parts:
• Swing and trapeze hooks should be in place on the top tube.
• Hardware for legs should be in place in the corner fittings.
• Hardware for support bars should be in place on the legs.
• Foam padding should be installed on each of the legs.
Step Illustration
Instructions
Hardware
Reference
1
Join the two sections of the top bar together
by connecting the center frame fitting with
the hardware that is already placed in the
top bar.
Part Ref. #: PSHW10
2
Remove the hardware from the center prong
of the corner fitting and insert the top bar.
Once the holes are aligned, re-insert the
hardware.
Part Ref. #: PSHW10
3
Repeat the process for the opposite corner
fitting. Then turn the top bar with the
attached corner fittings upside down to
prepare for the legs to be inserted.
Part Ref. #: PSHW10
4
Remove the hardware from the corner
fitting arms. Align the two sets of holes for
each leg and replace the hardware through
the corner fitting arms to secure the legs.
Do not over tighten the screws. After all
parts are assembled you will need to tighten
again.
NOTE: One leg has two holes near the
base. The see-saw attaches to this leg and
needs to be placed on the opposite side of
the slide.
Part Ref. #: PSHW10
5
Repeat the process for the center legs.
Then stand the swing set onto its legs.
Part Ref. #: PSHW10