PlaySafe 22-PS302 Owner's Manual - page 7
7
©2006 Pacific Cycle, Inc.
6
Remove the hardware from the middle
section of a leg. Match up the holes of the
mid-leg and support bar and re-insert the
hardware through both. Repeat the process
for the opposite side and center legs. It
may be necessary to pull both legs towards
each other in order for the holes to align
properly.
NOTE: One support bar has holes for the
slide attachment. The holes should be
positioned toward the front of the swing set.
Part Ref. #: PSHW12
SWING AND TRAPEZE ASSEMBLY
Pre-Assembled Parts
• Sling swing seats and trapeze should be attached to the chains.
Step Illustration
Instructions
Hardware
Reference
1
Hang the swings and trapeze in place from the
swing hooks.
NOTE: There should be plastic safety guards pre-
assembled on the swing hooks. Lift these up to
attach the chains and then put back in place.
2
Check the nuts on the underside of the trapeze to
make sure that they are secure.
Part Ref. #: PSSH11, PSHW13
DELUXE GLIDER ASSEMBLY
Required Parts:
Deluxe Glider Bracket x2
Bracket Bar x2
Pre-Assembled Parts:
• Swing hooks should be pre-assembled on the bracket bar.
• Chains should be attached to end sections of the deluxe glider.