Plinius 9200 Instruction Manual - page 12
11
Installation & Operation
WARNING: RISK OF ELECTRIC SHOCK
This amplifier operates at hazardous voltage levels. We recommend that any work
requiring removal of the lid be referred to a suitably qualified and experienced service
technician. DO NOT place this amplifier in any position where liquids or any foreign
material may accidentally enter it.
PLEASE READ & UNDERSTAND THE PRECAUTIONS WITHIN THIS MANUAL
FOR PLACEMENT & OPERATION OF THIS PRODUCT.
MAINS VOLTAGE CONNECTION
Firstly, check that the mains supply voltage printed on the rear of this amplifier is
similar to the mains supply voltage in your area. If in doubt, please consult your
Plinius dealer.
Mains supply power connection is via the supplied plug-in lead. A standard IEC
socket connects the mains power at the amplifier end, while a local mains plug is
required at the wall end.
The wiring code used inside all Plinius product is:
Green to Earth/Ground
Blue to Neutral
Brown to Phase/Live
Should a ‘local’ plug need fitting to the wall end of the lead, ensure that a suitably
qualified service technician wires the plug correctly.
DO NOT POWER UP YOUR AMPLIFIER UNTIL YOU HAVE CONNECTED
YOUR INPUT/OUTPUTS CORRECTLY FOR YOUR SYSTEM.
CONNECTIONS
Connections to your Plinius 9200 should be made in the same order as they are listed
in this section. DO NOT attempt to connect your Plinius 9200 until you have read and
fully understood these instructions. Should you require further assistance, please
contact your Plinius dealer.
SOURCE COMPONENT INPUTS
Connect your Source to the input of the Plinius 9200 using suitable single-ended RCA
or Balanced XLR interconnect cables only. For RCA, make sure you connect the red
coded cable to the red RIGHT RCA input, and the black (or white) cable to the black