Plinius 9200 Instruction Manual - page 9
8
Rear Panel Functions
This panel incorporates all terminals for connecting the input signals from your CD
player, tuner, etc and the outputs to the loudspeakers and mains supply. Please
remember that your Plinius 9200 Integrated Amplifier is a high quality electronic
instrument capable of an exceptional level of performance. Be sure that you understand
your system’s requirements fully before you make any connection to this amplifier.
1. MAINS SWITCH
The heavy-duty rocker switch in the centre of the panel turns the Mains/Line Power to
the amplifier ON or OFF. The amplifier draws a moderately high current when switched
on, so it is not good practice to rapidly turn the Mains switch on and off repeatedly.
2. INPUT TERMINALS
The input terminals for your Plinius 9200 Integrated Amplifier are easily accessible
along the top of the rear panel, with the right (red) inputs along the top. The phono
inputs are suitable only for low level input phono turntables, while the rest are all ‘line
level’ inputs, for use with unbalanced signals from line level source components such
as CD players, tuners, etc. There are also two tape input loops for recording and
playback. Consult your Plinius dealer for further advice if required.
3. CD XLR INPUT TERMINALS
Below the CD RCA inputs are an additional set of ‘line level’ XLR balanced inputs for
use with source components that feature XLR balanced outputs. Balanced signals are
carried via a three way cable.
The XLR pin configuration used in all Plinius product is:
PIN 1 to GND
PIN 2 to +Signal
PIN 3 to -Signal
NOTE: Because of the way our XLR and balanced inputs are configured it is not
possible to use both XLR and RCA at the same time.
1
6
2
3
6
4
7
8
9
5
5
10
12
13
14
11