Plinius 9200 Instruction Manual - page 8
7
Front Panel Functions
The front of the Plinius 9200 Integrated Amplifier incorporates all the facilities you will
require on a daily basis.
1. DISPLAY LED
An LED on the front panel indicates that the power is on. When first switched on,
the display LED will vary in brightness until the initialisation sequence is completed,
after which the LED remains lit. Whenever mute or a remote button is pressed, the
LED will dim.
2. RECORD SELECTOR
This rotary switch allows recording of any of the five different inputs. Note that when
recording, the source that is being listened to will not be interfered with. This allows
for listening to the one input whilst recording from another input. Two recording
devices can be connected and dubbing in either direction is possible. Note that in
standby mode no input is selected.
3. SOURCE SELECTOR
This rotary switch enables selection of any of the five different inputs available on the back
panel. This selection is fed to pre out terminals and the speakers via the output posts on
the rear of the amplifier. Note that in standby mode no input is selected.
4. VOLUME CONTROL
The volume control is an ALPS motorised unit that will accurately convey the source
signals to the power amplification stage of the Plinius 9200. The volume can be
adjusted manually or with the remote control supplied. When using the remote
control to alter the volume level, briefly press the button to make small adjustments, or
hold the button down to continuously adjust the volume.
1
3
4
2