Plinkusa KVM-1008JOSD User Manual - page 11
Note: Before you are not familiar with the operation of OSD manual, please don’t change
the password – i.e. keep default eight zero (00000000) value. Otherwise, if you have set the
password and unfortunately forget the password, you need send it back to your distributor
for maintaining the password.
The Push Buttons
:
Pressing the individual button cyclically through all the ports or the respective button to get
PC port you want.
PC port LED Indication :
You can press the button in order like mentioned-above diagram.
When you select the PC port and this PC is shut down or this PC port is disconnected to the
PC, the selected PC port LED will flash. When you select one of eight PCs ports and this
PC is powered on, the selected PC port LED is lit.
7-Segment BANK LED Indication
When you would like to view the next bank KVM switch, please press “ BANK “ push button
cyclically to the destination bank. The bank LED will be changed from bank 1 to the
maximum daisy chain level and then to press “ BANK “ push button once back to the bank
1.
Bank 1 Bank 2 Bank 3 MAX BANK
Reset Button (
(“ Bank ” button) and
(“ PC 1 ” button ) ):
To press both “PC1” button and “bank” button of master bank simultaneously can reset
KVM switch. This reset action will not only return KVM switch back to initial state --- Check
the password, but also re-check all of slave banks which connected to mast KVM Switch.
If you add a new KVM Switch as a slave bank, please use reset button of master KVM
Switch to automatically assign a new ID to it. You can view this new slave bank go through
OSD menu. The PC ports of KVM Switch does not be reset by reset command.
Keyboard Hot Key Commands:
You can also conveniently command KVM switch by switching ports through simple key
sequences. To send commands to KVM switch, the “SCROLL LOCK” key must be
pressed twice within 2 seconds. You will hear a beep for confirmation and the keyboard
is in hot key mode. If you have not pressed any key in hot key mode within 2 seconds (It
means to key in any key follows up “Scroll Lock” “Scroll Lock” key ), the keyboard will back
to under Operation System control state.
Below are the different hot key commands:
within 2 seconds
+ + = Previous Channel
9
Scroll
Lock
Scroll
Lock
↑