Plinkusa KVM-1008JOSD User Manual - page 16
To use “ Tab “ key to select items like Bank, OSD, SCAN, CHANGE PASSWORD,
CONSOLE ON/OFF, etc…
a. The “ OSD: 10 SEC” means
that the PC system name
exists 10 sec on your
monitor. You can modify it
from 05 sec to 99 sec. The
factory default value is 10
sec..
b. The “ SCAN TIME” means that scan interval from one PC port to next PC port. The
default SCAN time is 10 sec and the maximum scan time is 99 sec.
c. The “ CHANGE PASSWORD” is for user to avoid all PC systems to be intruded by the
other person. The default password is 8 digits “ 00000000 “.
There is an enter password window showed out when you select this item and then
press the Enter. The maximum password is eight digits. After you key in the password
already and press the Enter key, there is another window for confirming your typed
password.
You need to retype the password again for rechecking your previous key-in password
is matched or not.
d. The “ CONSOLE ON/OFF “ means to manage the console of KVM switch. If you select
“ CONSOLE ON “, it means that any user can use the console. If you select “ CONSOLE
OFF “(factory default OFF state), it means that any user will not be allowed to use the
console unless you enter the password. When you enter the
password already and pass the KVM switch authentication, the CONSOLE will be set
14
15
15☼
SYSTEM 15
16
SYSTEM 16
OSD :
1 0
SEC.
(
CHANGE PASSWORD
SCAN:
1 0
SEC. CONSOLE
ON
/OFF
ESC : QUIT
ENTER :COMPLETE
TAB : NEXT
INSERT :EDIT
ENTER PASSWORD :
█
ESC : QUIT
ENTER : COMPLETE
ENTER NEW PASSWORD :
█
ESC : QUIT
ENTER : COMPLETE
RETYPE NEW PASSWORD :
█
ESC : QUIT
ENTER : COMPLETE
NEW PASSWORD COMPLETE
ESC : QUIT
ENTER : COMPLETE