Plugz Electric Bike Instruction Manual - page 4
4
Handlebar / Stem / Headset: Stem and headset come pre-assembled. Loosen
the bolts on the stem, place the handlebar, center it and turn it until it is in your
preferred position, tighten the stem bolts simultaneously. Align the handlebar
perpendicularly to the front wheel, tighten the top stem bolt with a 6mm Allen key.
Pedals: The right-hand pedal (marked “R” on the pedal shaft) should be screwed
clockwise on the right-hand crank. The left pedal (marked “L”) should be screwed
counter-clockwise on the left-hand crank. Pedals should not be tightened firmly
but not excessively, as the crank threads are made of aluminum alloy. Use the
15mm spanner.
Seat post : Insert the seat post and saddle into
the seat tube, align set the hight and tighten the
quick release clamp.
Note! Do not adjust the seat post beyond its
maximum extension mark.
Basket:
Mount the bottom bracket on the fork with
the hex nut provided.
•Note the left and right of the pedal.
[L] Left [R] right
Attention: The threads will be stripped if
you attempt to mount the left pedal on the
right crank or the right pedal on the left
crank
.