Plugz Electric Bike Instruction Manual - page 7
7
CAUTION
If you notice a strange smell, or smoke or unusually high temperature, stop the
charging procedure immediately. Bring the battery and the charge to a Plugz
authorized dealer for service or replacement
Charge the battery in a dry, well ventilated area with a temperature between
32-100 degrees Fahrenheit.
The charger is designed for indoor use only. Keep the charger away from water to
avoid short circuit. Don’t use it in a damp room, or in an area with combustible or
explosive materials. Do not remove the wall plug by pulling on the cord. Always
hold the metal socket when plugging/unplugging the cord into/from the battery
DO NOT CHARGE THE BATTERY FOR MORE THAN 10 hours, especially in hot
weather, to avoid overcharging and damaging the battery. After the light turns
green, the charger is in “trickle” mode and will charge slowly to maintain the
charge. Do not leave the battery under charge if you are going to be away for
more than the expected charge time.
The charger will become warm during charging, so keep it away from any heat
source. Please always keep the charger dry and clean.
DO NOT OPEN THE BATTERY CASE, as it contains high voltage electronic parts,
and it will void your warranty
While charging, please keep it out of the reach of children. Do not put anything on
top of the charger. Prevent any liquid, metal or metal fillings from infiltrating the
charger
DO NOT TOUCH the two battery poles with your hands when handling the battery.
DO NOT TOUCH the battery charging connector poles with any metal or any
other material that conducts electricity, as it may cause a short circuit
The battery should be charged at least once per month if used or not. This will
ensure the battery life. DO NOT use the battery with a very low charge. Do not
leave your battery fully discharged for extended periods of time
Avoid any contact with water when charging your battery. If a plug or socket gets
wet, dry it completely before using it
Do not use sockets, connectors or other wiring devices providing power supplies
other than the standard AC 110V