Protherm Leopard 24 BOV User And Installation Instructions Manual - Control and Signaling
4
Main on/of switch
The main on/off switch (see fig.1) is on
the bottom of the boiler, below the control
panel.
Caution:
Commencing and first start of the
boiler operation may only be carried out by
a specialised service centre! Only turned on
boiler has activated all protective function
(e.g. anti-freeze protection).
Control panel
It serves for indication of actual parameters
and for setting or changing required values
this parameters.
1
- heating system pressure LED
( i n d i c a t i o n o f t h e h e a t i n g wa t e r
pressure)
2
- domestic hot water LED
(indication DHW taking or domestic hot
water temperature setting)
3
- central heating LED
(indication of the heat requirement or
heating temperature setting
4
- fault message LED
(indication of faults in boiler operation)
5
- decrease button (-)
( d e c r e a s e t h e s e t t i n g v a l u e o f
parameters)
6
- increasing button (+)
( i n c r e a s e t h e s e t t i n g v a l u e o f
parameters)
7
- display
(showing of pressure, temperatures,
s e r v i c e p a r a m e t e r s a n d f a u l t
messages)
8
- MODE button
(switches between setting modes and
corfirms setting value of parameters)
Control and Signaling
USER INSTRUCTONS
fi
g. 1
fi
g. 2