PS Audio MultiWave P600 Upgrade Instructions

1

Power Port Upgrade Instructions for P300 and P600 Power Plants 

Please read these instructions before attempting to install the new PS Audio Power Port AC 

receptacles in your P300 or P600 Power Plant.  These new receptacles replace the existing 

hospital grade receptacles and are designed to improve the performance of your Power Plant. 

Your kit contains the following: 

•  Power Ports 

•  New mounting hardware: 2 black screws (3 for P300) and two nuts for each Power Port 

•  Instruction manual 

Tools required: 

•  One small and one medium Phillips screwdriver 

•  Large heavy duty pair of wire-cutters or tin snips (pliers will also work) 

•  P600 only – Allen wrench originally supplied for removing top cover 

General Walk through 

The replacement of the rear-mounted outlets is rather simple.  Here are the basic steps you will 

be taking: 

1.  Disconnect your Power Plant from its power supply.   

2.  Place unit in a well-lit workspace and obtain all necessary tools. 

3.  Remove the bottom cover of a P300, or the top cover of a P600. 

4.  Remove the existing hospital grade outlets and replace with a Power Port. 

5.  Replace the top or bottom cover. 

6.  You are done. 

The procedure for replacing the hospital grade outlets with Power Ports, once inside the unit, is 

very similar for each model.  The differences per model are in gaining access to the inside of the 

unit, and re-attaching the plugs back onto the rear panel.  

Gaining access to inside the P300 

Step One 

Disconnect the Power Plant. 

IMPORTANT!  To correctly discharge the internal energy storage and prevent a potential shock 

hazard, you must unplug the Power Plant while it is turned on and providing power for at least 

one product.  This will not damage the Power Plant or the connected device.  However to ensure 

that your equipment does not get damaged we recommend you use a simple load device such as 

a table lamp for this step.  (It will typically take less then 5 seconds for the unit to fully discharge.) 

Once your Power Plant has cooled sufficiently to the touch, Place it in a well-lit place such as on 

a table or open floor where you can have easy access and plenty of space to work on it.  Make 

sure you have all required tools available.