PS Audio MultiWave P600 Upgrade Instructions - page 4
4
Attach the two ground tabs (two green wires each) to the mounting screw of the bottom outlet.
Use the screw that is nearest the ground terminal. The tabs go on after the Power Port and
mounting screw is inserted and right before the nut. This completes the ground for the CATV
filter and chassis.
Tighten the screws with your Phillips screwdriver while holding the inside nut in place with your
finger. The nut has a locking star washer that will dig into when tightened allowing you to easily
hold it in place with just your fingers.
Step Three
Check your work.
Make sure that the white wire is going to the side of the Power Port with the silver colored screw.
The black wire goes to the gold colored screw side. The green wires attach to the bottom corner
of the Power Port on a green screw.
Step Four
Replace the bottom cover, making certain that the oscillator PC board is firmly in place and the
fan is plugged into J9. You are done.
P600 attach the Power Port.
It is easiest if you attach outlets one and two first, four next, and three last, looking at the rear
panel from behind the Power Plant, reading left to right. Using this convention, you will find that
the most difficult outlet to attach is number four, behind the large transformer. If you do this one
before attaching the third one (from the left as you face the rear panel) you will find more room for
your fingers.
Step Two
Using the new hardware provided in the kit, replace the screw and nut that hold the Power Port in
place.
Tighten the screws with your Phillips screwdriver while holding the inside nut in place with your
finger. The nut has a locking star washer that will dig into when tightened allowing you to easily
hold it in place with just your fingers.
Step Three
Check your work.
Make sure that the white wire is going to the side of the Power Port with the silver colored screw.
The black wire goes to the gold colored screw side. The green wires attach to the bottom corner
of the Power Port on a green screw.
Make sure the fourth Power Port has its second green wire attached to the green binding post on
the rear panel.
Step Four
Replace the top cover. Congratulations, you are done. Your Power Plant is now equipped with
the latest power delivery technology available!!
PS Audio International, 3050 Broadway, Suite 201, Boulder Colorado, 80304 USA. 720-406-8946.
WWW.PSAUDIO.COM
Made in USA