PS Audio P3 Owner's Reference Manual - page 7
4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 service@psaudio.com www.psaudio.com
5
®
Operation Guide
©2012 PS Audio International Inc. All rights reserved.
Owner’s Reference
P3
Upon pressing either the left or right arrow button on the remote, a green LED will light above this
status. In this mode you have the ability to raise or lower the output voltage of the P3 using the
arrow buttons on your remote, and the display will show the user selected output voltage. After
approximately four seconds the P3 will revert to displaying the input voltage.
This indicator will be lit with a blue LED if the P3 has a viable internet connection.
An orange LED will light above this status if the P3 is outputting 90% of its potential.
If the P3 is outputting 100% of its potential a red LED will light above this status. If this status
indicator is lit the P3 is being pushed too hard and it will be necessary to either lower your
connected load or move some components to the HC zone.
There is no way to control the P3 directly from the front panel of the unit, but there are three quick
and easy ways to interact with and control your P3: a remote control that is included with the Power
Plant, an internal webpage that is accessed over your home’s Local Area Network via computer, and
over the internet via GlobalNet.
Remote Control
The remote control included with the P3 is going to be the easiest and most direct way to control
the Perfect Wave P3. The remote is line of sight, so please note that the P3 must be in sight to be
controlled in this manner. There are 7 buttons on the P3’s remote control.
Set
IP
90%
100%
Control Options
Remote Control