QMS CF 2215 User Manual - page 17
Configuring
Printer Memory
2-3
Installation
Configuring Printer Memory
This section provides information on configuring the emulation mem-
ory settings for the QMS MAGNUM emulation.
»
Note:
If your printer already has this memory correctly configured,
you can skip to the “Downloading the Emulation” section, later in this
chapter.
Reconfigure the Memory
You need to allocate at least 2 MB of K Mem Emulation memory on
any QMS 1060E/1660E/2025/3225/3825 Print System in order to
download and use the QMS MAGNUM emulation.
»
Note:
The printer may be unable to load the emulation until its
memory is reconfigured. QMS recommends that you add an
additional 4 MB of memory to any QMS Crown printer (except the
QMS 3825, which comes standard with 32 MB maximum memory) for
optimal QMS MAGNUM emulation support. Additional memory
allocated to optional emulations improves performance.
For this
printer...
You need to...
QMS 2025/
3225
Add 4 MB of additional RAM. Contact your QMS vendor
for information on ordering and installing additional
RAM. See appendix A, “QMS Customer Support,” for a
list of service and world-wide sales telephone numbers.
QMS 3825
No additional memory is required, so you only need to
reconfigure the printer’s memory. See "Configuring
Printer Memory" in the next section of this chapter, for
information on changing the K Mem Emulation memory
setting.