QMS CF 2215 User Manual - page 8
Introduction
QMS MAGNUM Emulation User's Guide
1-2
Introduction
The QMS MAGNUM emulation is compatible with the powerful indus-
trial graphics Code V programming language used on the QMS
CF2215 printer. It gives you advanced MAGNUM controller technol-
ogy (the standard for industrial graphics applications) designed to
meet your bar code, label, and form printing needs.
»
Note:
This emulation doesn’t support IBM interfaces.
System Requirements
To use the QMS MAGNUM emulation, you need the following:
For this
system
requirement...
You need...
QMS Crown
Printer
The QMS MAGNUM emulation is available only on the
following QMS Crown printers at the specified (or
greater) software release level:
—QMS 1060E Print System (software release 2.0.15)
—QMS 1660E Print System (software release 2.0.15)
—QMS 2025 Print System (software release 8.2.0)
—QMS 3225 Print System (software release 8.2.0)
—QMS 3825 Print System (software release 8.2.0)
Hard Disk
Either an external or an internal hard disk is required to
load the QMS MAGNUM emulation on any of the above
QMS Crown printers.
Memory
4 MB more than standard memory is required to load
the QMS MAGNUM emulation on any of the above
printers except the QMS 3825, which comes standard
with maximum memory of 32 MB.