QMS CF 2215 User Manual - page 19
Configuring
Printer Memory
2-5
Installation
»
Note:
To configure this memory client to 2 MB (2048 KB)
minimum, you may need to take memory away from the
Administration/Memory/Framebuffer memory client. Keep in mind
that a memory setting can be equal to or higher than the
minimum value, but it can’t be lower than that value.
A numerical value is displayed (expressed as a 5-digit number),
showing the current memory setting for that specific memory
selection. Using the Previous or Next key, change the value of
each digit (up or down) to reflect the new 2 MB (2048 KB) mem-
ory setting.
You change one digit at a time much like setting the time and date
on a digital watch. The current input digit is highlighted and the
cursor flashes. When you have reached the correct digit, press
the Select key once. This accepts the displayed digit and moves
the cursor to the next digit. After the last digit is entered, press the
Select key to complete the change. The new memory setting is
displayed for a moment, and then the current Memory menu
selection displays. (See the example that follows this procedure.)
If you set the wrong value for this memory client, repeat this step.
If you are unable to allocate 2 MB (2048 KB) to the Administra-
tion/Memory/K Mem Emulation client and Administration/Mem-
ory/Framebuffer is configurable on your printer, then complete
step 3 first and return to this step; otherwise continue at step 4.
3
If you are unable to change the Administration/Memory/K
Mem Emulation value to 2 MB (2048 KB), then first change
the Administration/Memory/Framebuffer setting to a lower
value, if it is configurable on your printer.
Access Administration/Memory/Framebuffer and choose a
smaller media size at the same or a lower resolution. For exam-
ple, when using a QMS 1060E Print System with 12 MB of RAM,
the default media size is Legal and the resolution is 600 DPI.
Change it to A4 media size at 600 DPI. After you have decreased
the Framebuffer memory requirements, then return to step 2.