QT Big Button Instruction Manual - page 6
MAKING A CALL
¾
From the handset
1. Lift the Handset
2. When you hear dial tone, dial the desired number.
3. The telephone will start to time the conversation after 6 seconds.
4. To end the call, return the handset to the base.
¾
Pre-dialing function
1. When the handset is on the base (in on hook condition), dial the desired number.
2. If a mistake is made, use the
DEL key to delete the incorrect digit.
3. Press
key or pick up the handset, the number will be dialed automatically.
4. When a call is established, lift the handset to converse with the other party.
5. To end the call return the handset to the base.
¾
Redial
1. Pick up the handset,
2. Press
the
RD key, the last dialed number will be dialed again
REVIEWING, CALLING BACK AND DELETING INCOMING NUMBERS
¾
Reviewing
In on-hook state, press
▲ or ▼ key to scroll through and review stored incoming numbers.
¾
Calling back
In on-hook state, scroll to the desired number, press
or RD key or pick up the handset, the
number is dialed out. Or press the
RD key twice, the long distance code will be added ahead of
the telephone number automatically and the number will be dialed.
NOTE: If the PABX code is set, the telephone will detect and add the PABX code before the
number automatically and then dial the number. The PABX code will be dialed first, followed by a
2 second pause, followed by the telephone number.
¾
Deleting
In on-hook state when the desired number is displayed on the LCD; press the
DEL key, the
number is then deleted. Or press and hold the
DEL key for 3 seconds, all the stored incoming
numbers will be deleted.
REVIEWING, CALLING BACK AND DELETING OUTGOING NUMBERS
¾
Reviewing
In on-hook state, press the
OUT key, then repeatedly press the OUT key to review the outgoing
numbers one by one.
¾
Calling back
In on-hook state, press the
OUT key to review the desired number, then press
or RD key or
pick up the handset, and the number is dialed out.
5