QT Big Button Instruction Manual - page 8
7
¾
Adjusting LCD Contrast
1. In on-hook state, press the
MENU key and press ▲ key three times, the LCD displays SET 4
LCD, Press the MENU key again, LCD displays LCD 5
2. Press
▲ or ▼ key to adjust the LCD contrast, a total of 8 levels can be selected.
3. Press
the MENU key to confirm and exit.
¾
Setting Flash Time
1. In on-hook state, press the
MENU key and press ▲ key four times, the LCD displays SET 5
FLASH, press the MENU key again, the LCD displays FLASH 100
2. Press
▲ or ▼ key to select a flash time of 100, 300, 600 and 1000ms (for RSA Flash Time
should be set to 100ms).
3.
Press the
MENU key to confirm.
¾
Setting PABX Code
1. In
on-hook
state, press and hold the
DEL key for 3 seconds to set the PABX code, the LCD
displays
PCODE - and the “-” flashes.
2. Press
▲ or ▼ key to set the PABX code from 0 to 9 or “-“
3. If “-” is selected, then no PABX code is set.
4. Press
the
MENU key to confirm and to exit the setting.
¾
Setting Alarm Clock
1. In on-hook state, press
the ALM/P key once, the LCD displays 12-00 AL1,
2. Press
▲ or ▼ key to set the alarm ON or OFF. LCD displays the “ALM” icon when the alarm
is set to ON.
3. Press the
MENU key, the digit “12” starts to flash.
4. Press
▲ or ▼ key to set the alarm hour and press the MENU key again to confirm and to
enter into the alarm minute setting.
5. Press
▲ or ▼ key to set the alarm minute and press the MENU key to confirm and to enter
into the next group of the alarm clock settings.
6. Repeat the above procedure to set additional alarms.
7. Any key can be pressed to turn off the alarm when it is sounding.
NOTE: The first 3 groups of alarm clock settings will be repeated every day while the last 2
groups of alarm clock settings are once off settings.
VOICE ANNOUNCEMENT SETTINGS
Connect a DC adaptor (use only power supply model GCE 0900030C Input: 100-240VAC,
Output: 9V 300mA (centre positive))
or insert batteries for the following two features to function.
The voice announcement button (“talking set”) is at the bottom of the phone base.
The default setting for voice announcement is set to ON.