Quadra-Fire 41I-ACC Owner's manual - page 19
October 22, 2013
7045-909
19
41I-ACC
E. Glass Cleaning
• Frequency:As desired
• By:Homeowner
• Clean glass with a non-abrasive glass cleaner. Abrasive
cleaners may scratch and cause glass to crack.
• If the deposits on the glass are not very heavy, normal
glass cleaners work well. Heavier deposits may be
removed by using a damp cloth dipped in wood ashes or
by using a commercially available oven cleaner.
• After using an oven cleaner, it is advisable to remove any
residue with a glass cleaner or soap and water. Oven
cleanerleftonduringthenextfiringcanpermanentlystain
theglassanddamagethefinishonplatedmetalsurfaces.
• Aportionofthecombustionairenteringthefireboxisde-
flecteddownovertheinsideofthedoorglass.
• Thisairflow“washes”theglass,helpingtokeepsmoke
from adhering to its surface.
• Whenoperatedatalowburnrate,lessairwillbeflowing
over the glass and the smoky, relatively cool condition of
alowfirewillcausetheglasstobecomecoated.
•
Operating the appliance with the Burn Rate Air Control
and Start-Up Air Control all the way open for 15-20 min-
utes should remove the built up coating.
CAUTION! Handle glass assembly with care. Glass is
breakable
.
• Avoidstriking,scratchingorslammingglass
• Avoidabrasivecleaners
• Donotcleanglasswhileitishot
F. Inspect Firebrick
• Frequency:After each ash removal
• By: Homeowner
Replacethefirebrickiftheybecomecrumblyand/orifthere
is a 1/4 inch (6.35mm) gap between the bricks.
Thefireboxislinedwithfirebrick,whichhasexceptionalin-
sulatingproperties.Donotuseagrate;simplybuildafireon
thefireboxfloor.Donotoperateappliancewithoutfirebrick.
1. After the coals have completely cooled, remove all old
brickandashfromunitandvacuumfirebox.
2. Remove new brick set from box and lay out to the diagram
shown in the instructions that come with the brick set or
refer to the diagram on the service parts list at the end
of this manual.
3. Lay bottom bricks in unit.
4. Install rear bricks on the top of the bottom bricks. Slide
topofbricksundercliponbackoffireboxwallandpush
bottom of bricks back.
5. Install side bricks. Slide top of brick under clips on side
offireboxandpushthebottomofthebrickuntilitisflush
with the side of the unit.