1. DL manuals
  2. Quadra-Fire
  3. Stove
  4. SANTAFEI-MBK
  5. Installation Manual

Quadra-Fire SANTAFEI-MBK Installation Manual

Manual is about: fireplace

Summary of SANTAFEI-MBK

  • Page 1

    1 7019-230c may 18, 2015 santa fe pellet insert stove model(s): santafei-mbk installation manual installation & appliance set-up installer: leave this manual with party responsible for use and operation. Owner: retain this manual for future reference. Notice: do not discard this manual o-t l tested ...

  • Page 2

    2 7019-230c may 18, 2015 santa fe pellet insert table of contents safety alert key: • danger!Indicates a hazardous situation which, if not avoided will result in death or serious injury. • warning! Indicates a hazardous situation which, if not avoided could result in death or serious injury. • cauti...

  • Page 3

    May 18, 2015 7019-230c 3 santa fe pellet insert model santa fe pellet insert laboratory omni test laboratories, inc. Report no. 061-s-77d-6.2 type solid fuel room heater/pellet fuel burning type insert standard astm e1509-2004, ulc s628-93 and ulc/ord-c1482-m1990 room heater pellet fuel burning type...

  • Page 4: Install Guide

    4 7019-230c may 18, 2015 santa fe pellet insert install guide 2 getting started marginal location: • below peak location not recommended: • not the highest point of the roof • wind loading possible multi-level roofs windward leeward recommended: outside air intake on windward side not recommended: o...

  • Page 5

    May 18, 2015 7019-230c 5 santa fe pellet insert warning hearth & home technologies disclaims any responsibility for, and the warranty will be voided by, the following actions: • installation and use of any damaged appliance. • modifi cation of the appliance. • installation other than as instructed b...

  • Page 6

    6 7019-230c may 18, 2015 santa fe pellet insert attention installer: follow this standard work checklist this standard work checklist is to be used by the installer in conjunction with, not instead of, the instructions contained in this installation manual. Customer: date installed: lot/address: loc...

  • Page 7

    May 18, 2015 7019-230c 7 santa fe pellet insert figure 7.3- front view figure 7.1 - top view figure 7.2 -side view 21-1/2” (546mm) 28-7/8” (733mm) 23-5/8” (600mm) 8” (203mm) cl 12-3/4” ( 324mm) 8-5/8” ( 219mm) 23” ( 584mm) 25-3/8” ( 645mm) panel a b standard 40 inches (1016mm) 30 inches (762mm) larg...

  • Page 8

    8 7019-230c may 18, 2015 santa fe pellet insert fire risk comply with all minimum clearances to combustibles as specifi ed. Failure to comply may cause house fi re. Warning note: • illustrations refl ect typical installations and are for design purposes only. • i llustrations/diagrams are not drawn ...

  • Page 9

    May 18, 2015 7019-230c 9 santa fe pellet insert a b c d d. Minimum opening for masonry and zero clearance fireplaces inches millimeters a insert side to combustible side wall 16 406 b insert top to mantel 12 305 c insert top to maximum. 2-1/4 inch (57mm) face trim 4-3/4 121 d insert side to maximum....

  • Page 10: Warning

    10 7019-230c may 18, 2015 santa fe pellet insert mark area of floor to cut starter hole use 2 x 4 from insert packaging to support insert g. Installation into a factory-built fireplace the following modifi cations are permissible: • removal of damper or locked in open position • removal of smoke she...

  • Page 11

    May 18, 2015 7019-230c 11 santa fe pellet insert keep sharp edge of metal floor away from power cord leveling leg figure 11.1. Place the insert into the facto- ry-built fi rebox. Ensure that the power cord can not be damaged by the sharp metal edge. You may need to cut out a notch to accommodate the...

  • Page 12

    12 7019-230c may 18, 2015 santa fe pellet insert 4 vent information a. Venting termination minimum requirements j or k x v m i h a v g b v v a b v f v c b b e l v d v electrical service v n v n v n n v inside corner fixed closed open open fixed closed v x g g termination cap air supply inlet gas met...

  • Page 13

    May 18, 2015 7019-230c 13 santa fe pellet insert b. Avoiding smoke and odors negative pressure, shut-down and electrical power failure to reduce the probability of back-drafting or burn-back in the pellet appliance during power failure or shut down con- ditions, it must be able to draft naturally wi...

  • Page 14

    14 7019-230c may 18, 2015 santa fe pellet insert c. Negative pressure negative pressure results from the imbalance of air avail- able for the appliance to operate properly. It can be strongest in lower levels of the house. Causes include: • exhaust fans (kitchen, bath, etc.) • range hoods • combusti...

  • Page 15

    May 18, 2015 7019-230c 15 santa fe pellet insert fire risk. • only listed venting components may be used. • no other vent components may be used. • substitute or damaged vent components may impair safe operation. Warning risk of injury or property damage! • improper installation, adjustment, alterat...

  • Page 16

    16 7019-230c may 18, 2015 santa fe pellet insert note: in canada, where passage through a wall or partition of combustible construction is desired, the installation shall conform to can/csa-b365. Figure 15.1 fire risk. Inspection of chimney: • masonry chimney must be in good condition. • meets minim...

  • Page 17

    May 18, 2015 7019-230c 17 santa fe pellet insert b. Full reline with outside air - vertical figure 16.3 note: check clearances carefully for this type of instal- lation to ensure adequate room for outside air venting. Check building codes prior to installation. • installation must comply with local,...

  • Page 18

    18 7019-230c may 18, 2015 santa fe pellet insert 6 appliance set-up a. Leveling system the leveling bolts are located at the rear of the appliance. To access the bolts, remove the front access panels. Reach in and turn the bolt to the desired height to level the appliance. B. Outside air kit instruc...

  • Page 19

    May 18, 2015 7019-230c 19 santa fe pellet insert figure 18.1 grille bracket cover (shipped flat from factory) finger bend into position after grilles are installed on appliance insert heat exchanger rods through holes on second grille. Heat exchanger rods install bottom 3 grilles before installing s...

  • Page 20

    20 7019-230c may 18, 2015 santa fe pellet insert f. Adjustable hearth support size: 9”d x 45”w, 2” to 10” height adjustment included in kit: (1) trim top, (1) trim front, (2) trim sides, double-sided tape (already installed) tools needed: phillips head screwdriver, sheet metal shears, measuring tape...

  • Page 21

    May 18, 2015 7019-230c 21 santa fe pellet insert access panels open hopper lid for easier placement of panel set magnet hook figure 20.4 figure 20.2 figure 20.3 figure 20.1- completed view g. Panel and trim set 1. Lay panel top and legs face down on protective covering to prevent scratching. 1. Atta...

  • Page 22

    22 7019-230c may 18, 2015 santa fe pellet insert figure 21.1 shock hazard. • do not remove grounding prong from plug. • plug directly into properly grounded 3 prong receptacle. • route cord away from appliance. • do not route cord under or in front of appliance. Caution junction box cut away left si...

  • Page 23

    May 18, 2015 7019-230c 23 santa fe pellet insert 7 mobile home installation you must use a quadra-fire outside air kit for installation in a mobile home. 1. An outside air inlet must be provided for the combustion air and must remain clear of leaves, debris, ice and/or snow. It must be unrestricted ...

  • Page 24

    24 7019-230c may 18, 2015 santa fe pellet insert 8 accessory list accessories adjustable hearth support 12” x 50”, 2-10” h adjspt-12 9” x 45”, 2-10” h 841-0990 log set logs-30-oe log, rear left 7050-144 log , rear right 7050-143 outside air kit, rear 811-0872 channel, air intake 413-7040 cover, outs...

  • Page 25

    May 18, 2015 7019-230c 25 santa fe pellet insert.

  • Page 26

    26 7019-230c may 18, 2015 santa fe pellet insert.

  • Page 27

    May 18, 2015 7019-230c 27 santa fe pellet insert.

  • Page 28

    28 7019-230c may 18, 2015 do not discard this manual caution • important operating and maintenance instruc- tions included. • leave this manual with party responsible for use and operation. • read, understand and follow these instruc- tions for safe installa- tion and operation. Do not discard conta...