1. DL manuals
  2. Quadra-Fire
  3. Stove
  4. SANTAFEI-MBK
  5. Installation Manual

Quadra-Fire SANTAFEI-MBK Installation Manual

Manual is about: fireplace

Summary of SANTAFEI-MBK

  • Page 1

    1 7019-230g june 5, 2017 santa fe pellet insert appliance model: santafei-mbk installation manual installation & appliance set-up installer: leave this manual with party responsible for use and operation. Owner: retain this manual for future reference. Notice: do not discard this manual o-t l tested...

  • Page 2

    2 7019-230g june 5, 2017 santa fe pellet insert table of contents safety alert key: • danger!Indicatesahazardoussituationwhich,ifnotavoidedwillresultindeathorseriousinjury. • warning!Indicatesahazardoussituationwhich,ifnotavoidedcouldresultindeathorseriousinjury. • caution!Indicatesahazardoussituati...

  • Page 3

    June 5, 2017 7019-230g 3 santa fe pellet insert model santafepelletinsert laboratory omnitestlaboratories,inc. Report no. 061-s-77d-6.2 type solidfuelroomappliance/pelletfuel burningtypeinsert standard astme1509-2004,ulcs628-93and ulc/ord-c1482-m1990roomappli- ancepelletfuelburningtypeand(um) 84-hud...

  • Page 4: Install Guide

    4 7019-230g june 5, 2017 santa fe pellet insert install guide 2 getting started marginal location: • below peak location not recommended: • not the highest point of the roof • wind loading possible multi-level roofs windward leeward recommended: outside air intake on windward side not recommended: o...

  • Page 5

    June 5, 2017 7019-230g 5 santa fe pellet insert warning hearth&hometechnologiesdisclaimsany responsibilityfor,andthewarrantywillbevoided by,thefollowingactions: •installationanduseofanydamagedappliance. •modificationoftheappliance. • installationotherthanasinstructedbyhearth&home technologies. • ins...

  • Page 6

    6 7019-230g june 5, 2017 santa fe pellet insert e. Install checklist appliance install appliance is leveled and connector is secured to appliance. Hearth extension size/height decided. Outside air kit installed. Floor protection requirements have been met. If appliance is connected to a masonry chim...

  • Page 7

    June 5, 2017 7019-230g 7 santa fe pellet insert figure 7.2- front view with small basic panel set figure 7.1 - top view figure 7.3 -side view 8 in [203mm] 28-7/8 in [732mm] 23-5/8 in [600mm] 9-5/8 in [246mm] 11-1/8 in [283mm] 21-1/2 in [546mm] 12-3/4 in [325mm] 9-1/2 in [243mm] 30 in [762mm] 40 in [...

  • Page 8

    8 7019-230g june 5, 2017 santa fe pellet insert b. Clearance to combustibles, ul and ulc note: • illustrationsreflecttypicalinstallationsandarefor designpurposesonly. • i llustrations/diagramsarenotdrawntoscale. • actualinstallationmayvaryduetoindividualdesign preference. Firerisk. Complywithallmini...

  • Page 9

    June 5, 2017 7019-230g 9 santa fe pellet insert c d a b c. Minimum opening for masonry and zero clearance fireplaces figure 9.1 figure 9.2 side trim hearth extension 29-3/4 in (1010mm) side w all top trim 26-3/4 in (679mm) 20-3/4 in (527mm) 16 in (406mm) figure 9.3 firepla ce fr ont surf ace mantel ...

  • Page 10: Warning

    10 7019-230g june 5, 2017 santa fe pellet insert mark area of floor to cut starter hole use 2 x 4 from insert packaging to support insert d. Installation into a factory-built fireplace thefollowingmodificationsarepermissible: • removalofdamperorlockedinopenposition • removalofsmokeshelforbaffle • re...

  • Page 11

    June 5, 2017 7019-230g 11 santa fe pellet insert keep sharp edge of metal floor away from power cord leveling leg figure 11.1.Placetheinsertintothefacto- ry-builtfirebox.Ensurethatthepowercord can not be damaged by the sharp metal edge.Youmayneedtocutoutanotchto accommodatethecord. Figure 11.2.Ensur...

  • Page 12

    12 7019-230g june 5, 2017 santa fe pellet insert 4 vent information a. Venting termination minimum requirements j or k x v m i h a v g b v v a b v f v c b b e l v d v electrical service v n v n v n n v inside corner fixed closed open open fixed closed v x g g termination cap air supply inlet gas met...

  • Page 13

    June 5, 2017 7019-230g 13 santa fe pellet insert b. Avoiding smoke and odors negative pressure, shut-down and electrical power failure to reduce the probability of back-drafting or burn-back in thepelletapplianceduringpowerfailureorshutdowncon- ditions, it must be able to draft naturally without exh...

  • Page 14

    14 7019-230g june 5, 2017 santa fe pellet insert c. Negative pressure negative pressure results from the imbalance of air avail- ablefortheappliancetooperateproperly.Itcanbestrongest inlowerlevelsofthehouse. Causesinclude: • exhaustfans(kitchen,bath,etc.) • rangehoods • combustion air requirements f...

  • Page 15

    June 5, 2017 7019-230g 15 santa fe pellet insert fire risk. • onlylistedventingcomponentsmaybeused. • nootherventcomponentsmaybeused. • substituteordamagedventcomponentsmay impairsafeoperation. Warning risk of injury or property damage! •improperinstallation,adjustment,alteration,service ormaintenan...

  • Page 16

    16 7019-230g june 5, 2017 santa fe pellet insert note:incanada,wherepassagethroughawallorpartitionof combustibleconstructionisdesired,theinstallationshallconform tocan/csa-b365. Figure 15.1 fire risk. Inspectionofchimney: • masonrychimneymustbeingoodcondition. • meetsminimumstandardofnfpa211 • facto...

  • Page 17

    June 5, 2017 7019-230g 17 santa fe pellet insert b. Full reline with outside air - vertical figure 17.3 note: checkclearancescarefullyforthistypeofinstal- lationtoensureadequateroomforoutsideairventing. Checkbuildingcodespriortoinstallation. • installation must comply with local, regional, state and...

  • Page 18

    18 7019-230g june 5, 2017 santa fe pellet insert 6 appliance set-up a. Leveling system thelevelingboltsarelocatedattherearoftheappliance.To accessthebolts,removethefrontaccesspanels.Reachin andturnthebolttothedesiredheighttoleveltheappliance. B. Outside air kit instructions partsincludedinkit:1piece...

  • Page 19

    June 5, 2017 7019-230g 19 santa fe pellet insert figure 19.1 grille bracket cover (shipped flat from factory) finger bend into position after grilles are installed on appliance insert heat exchanger rods through holes on second grille. Heat exchanger rods install bottom 3 grilles before installing s...

  • Page 20

    20 7019-230g june 5, 2017 santa fe pellet insert f. Adjustable hearth support size: 9”d x 45”w, 2” to 10” height adjustment included in kit: (1)trimtop,(1)trimfront,(2)trimsides, double-sidedtape(alreadyinstalled) tools needed: phillipsheadscrewdriver,sheetmetal shears,measuringtape,gloves 1. The 10...

  • Page 21

    June 5, 2017 7019-230g 21 santa fe pellet insert access panels open hopper lid for easier placement of panel set magnet hook figure 21.4 figure 21.2 figure 21.3 figure 21.1- completed view g. Panel and trim set 1. Laypaneltopandlegsfacedownonprotectivecovering topreventscratching. 1. Attach the pane...

  • Page 22

    22 7019-230g june 5, 2017 santa fe pellet insert figure 22.1 shockhazard. • donotremovegroundingprongfromplug. • plugdirectlyintoproperlygrounded3prong receptacle. • routecordawayfromappliance. • donotroutecordunderorinfrontofappliance. Caution junction box cut away left side junction box, front pow...

  • Page 23

    June 5, 2017 7019-230g 23 santa fe pellet insert figure 23.3 figure 23.4 j. Optional log set placement two piece log set installation 1. Opendoortoexposethefirebox. 2. Install the left log firstandthentherightlog. Figure 23.3 3. Leanthelogsagainstthecastironbrickinthebackof thefirebox. 4. Pushthelog...

  • Page 24

    24 7019-230g june 5, 2017 santa fe pellet insert 7 mobile home installation you must use a quadra-fire outside air kit for installation in a mobile home. 1. Anoutsideairinletmustbeprovidedforthecombustionairand mustremainclearofleaves,debris,iceand/orsnow.Itmust beunrestrictedwhiletheapplianceisinus...

  • Page 25

    June 5, 2017 7019-230g 25 santa fe pellet insert 8 reference materials a. Service & maintenance list date of service performed by description of service.

  • Page 26

    26 7019-230g june 5, 2017 santa fe pellet insert date of service performed by description of service.

  • Page 27: Santafei-Mbk

    June 5, 2017 7019-230g 27 santa fe pellet insert service parts r santafei-mbk beginning manufacturing date: dec. 2009 ending manufacturing date: active important: this is dated information . Parts must be ordered from a dealer or distributor. Hearth and home technologies does not sell directly to co...

  • Page 28

    28 7019-230g june 5, 2017 contact information hearth & home technologies 352 mountain house road halifax, pa 17032 division of hni industries please contact your quadra-fire dealer with any questions or concerns. For the number of your nearest quadra-fire dealer log onto www.Quadrafire.Com do not di...