Quadra-Fire SANTAFEI-MBK Installation Manual - page 20
20
7019-230G
June 5, 2017
Santa Fe Pellet Insert
F. Adjustable Hearth Support
Size: 9”d x 45”w, 2” to 10” Height Adjustment
Included in Kit: (1)trimtop,(1)trimfront,(2)trimsides,
double-sidedtape(alreadyinstalled)
Tools Needed: Phillipsheadscrewdriver,sheetmetal
shears,measuringtape,gloves
1. The 10 screws on each set of scissors will already be
loosewhenshipped.
Figure 20.1.
2. Expand scissors to desired height. Tighten screws to
hold in place using Phillips head screwdriver.
Figure
20.2.
3. Measurefrontandsidetrimstorequiredheighttocover
scissorsandmarkpiecesforcutting.Cutexcessmate-
rialfrom
topoftrimsedge,notbottom.Thisedgewill
be sharp; wear gloves to prevent injury to your hands.
Figure 20.3.
4. Using sheet metal shears, cut trim along the marked
edge.Thecutedgefitsunderlipoftoptrim,soitallows
forsomevarianceinyourstraightedge.
5. Thedouble-sidedtapethatholdsfrontandsidetrimsto
scissorshasapowerfulbondingadhesive.Adjustments
areextremelydifficultoncetrimhasadheredtotape.Do
adryrunfirstwithoutremovingpaperfromtape.
6. Placecutedgeoftrimundertoplipandintopositionon
scissors.Placesidepiecesonfirstandthenfrontpiece.
Thefrontpieceoverlapssidepieces.
7. Onceyouaresatisfiedwiththepositioning,removetrim
andsetaside.
8. Remove the paper from double-sided tape that is to
accepttrimside.Alignsideandthenpresshardagainst
tapetosecuresidepiece.Repeatforotherside.Install
fronttrimpiecelast.
9. Thereare3holesinthebackflangeofthetoptosecureit
tothewallifnecessary.Usetheappropriatefastenerfor
thetypeofwallmaterial,i.e.,brick,sheetrock,etc.
NOTE:3/8inch(9.5mm)thicktileorlikematerialcanbe
cuttosizeandfitunderlipoftoptrimedgeforadecora-
tivetouch.
Figure 19.3.
Figure 20.1
Figure 20.2
Figure 20.3
Figure 20.4
WARNING
Sheetmetaltrimedgeswillbesharp.Forsafety
purposesweargloves.
Injurycanoccur.
DOUBLE-SIDED TAPE
DOUBLE-SIDED TAPE
SCREWS ARE CIRCLED
EXPLODED VIEW OF SCISSORS
Decorative tile
may be installed
INSTALL FRONT TRIM LAST.
CORNERS OVERLAP SIDE
TRIM PIECES
EXPAND SCISSORS TO DESIRED HEIGHT
CUT TOP EDGE OF TRIM,
NOT BOTTOM EDGE