Quality Craft MM905-54BCP Instruction Manual

Summary of MM905-54BCP

  • Page 1

    1 important: please note when you open the carton, carefully check the unit and make sure there is no damage. If you have any problems with assembling the unit, with how the various functions work or with damage or missing parts please call 1-800-459-4409 (9:00am - 5:00pm est) immediately for servic...

  • Page 2

    2 remember to observe all safety warnings at all times. The fireplace heater has safety overheat protection. If the overheat protection trips, switch off all switch buttons and wait approximately 5 -10 minutes. It should reset automatically once the unit cools down. Warning: procedures and technique...

  • Page 3

    3 (pre-drilled) screws to adjust the plastic connector until the kd screws are able to be installed. Tighten all kd screws once all panels are assembled. Step 1: attach all plastic connector [x] to panels a, b, c and d with kd screws (2 screws for each plastic connector). See fig. A. Fig. A step 2: ...

  • Page 4

    4 caution: centre of grill may get hot during operation. Do not touch center of front grill when opening. O/i: press this button for main power. The indicator light will turn on. Standby switch. Press this switch once the unit becomes energized and you can select the following functions as desired. ...

  • Page 5

    5 maintenance warning: disconnect power and unplug the power cord before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. The bulbs in your unit can become extremely hot. Allow at least 10 minutes between turning off the unit and removing the li...

  • Page 6

    6 2. Drill the holes with diameter 3/4 inches (10 mm) and depth 3/4 inches (10 mm) on the mantel. Each plastic connector needs 3 holes. See fig. C. Fig. C fig. D 3. Gently install the kd nuts into the drilled-holes with hammer as shown in fig. D. 4. Attach the plastic connector and lock in place wit...