Quality Craft MM905-54BCP Instruction Manual - page 3
3
(PRE-DRILLED) SCREWS TO ADJUST THE PLASTIC CONNECTOR
UNTIL THE KD SCREWS ARE ABLE TO BE INSTALLED. TIGHTEN
ALL KD SCREWS ONCE ALL PANELS ARE ASSEMBLED.
Step 1: Attach all plastic connector [X] to panels A, B, C and D
with KD screws (2 screws for each plastic connector). See Fig. A.
fig. A
Step 2: Attach base support panel [D] to the bottom of base [B]
with 2 KD screws [W]. Attach panel E, F, G and H on the top of
base [B] with 8 KD screws [W]. See Fig. B.
fig. B
Step 3: Attach back panel [C] to base [B] with 3 KD screws [W] as
shown in Fig. C.
fig. C
Step 4: Attach top panel [A] to the unit as shown in Fig. D with 11
KD screws [W].
fig. D
Step 5: Tighten all screws.
OPERATION
After reading complete instructions, confirm all controls on
fireplace are in the OFF position. Plug the fireplace into a
15AMP/120Volt outlet. If the cord does not reach, you may use
an extension cord rated for a minimum of 1875 WATTS. Once the
fireplace insert has been properly connected to a grounded electri-
cal outlet, it is ready to operate.
OPERATION BY THE CONTROL PANEL
The controls are located behind the grill below the front glass and
can be accessed by pulling the grill from the top, forward and
down.