Quality Craft MM905-54BCP Instruction Manual - page 5
5
MAINTENANCE
WARNING:
Disconnect power and unplug the power cord before attempting
any maintenance or cleaning to reduce the risk of fire, electric
shock or damage to persons. The bulbs in your unit can become
extremely hot. Allow at least 10 minutes between turning off the
unit and removing the light bulbs to avoid the accidental burning of
the skin.
RISK OF FIRE: DO NOT ExCEED THE RECOMMENDED BULB
WATTAGE.
REPLACING THE LIGHT BULBS
Step 1: Remove 14 screws on the back of fireplace and open
the rear cover. There are 2 larger screws and 12 smaller
screws.
Step 2: You will find 1 X 40W Type B-10 bulbs under log-set bed.
Step 3: Loosen and remove the burnt out bulb and replace with
new bulb.
Step 4: Close the rear cover. Secure the larger screws into the top
left corner hole and bottom right corner holes as shown
in the diagram. Secure the 12 smaller screws into the
remaining holes. Make sure the screws are in the correct
holes and have been tightened.
Step 5: Plug in the unit.
REPAIR SET
TOUCH-UP REPAIR PAINT
Paint directly on the mantel unit if necessary. Fig. A.
Fig. A
REPAIRS
If any problems are found with the original parts during mantel
assembly such as the panels cannot be installed with the plastic
connector. Try to solve by one of the following methods.
Tools required: Electric drill, drill bits 3/4 inches (10 mm) or 1/16
inches (2 mm), pencil, hammer, Philips screwdriver, safety goggles
and gloves (if necessary).
WARNING: Wear goggles before you start drilling.
Option 1:
Use the spare KD NUTS, KD SCREWS and PLASTIC CONNECTOR.
1. Place the PLASTIC CONNECTOR on the mantel unit and mark the
drill-holes as shown in Fig. B.
Fig. B