Quality Craft MM905-54BCP Instruction Manual - page 4
4
CAUTION: CENTRE OF GRILL MAY GET HOT DURING OPERATION.
DO NOT TOUCH CENTER OF FRONT GRILL WHEN OPENING.
O/I: Press this button for main power. The indicator light will turn
on.
Standby switch. Press this switch once the unit becomes
energized and you can select the following functions as desired.
Press this switch again. The unit will be OFF and enter standby
mode.
Press this button once for flame effect. The unit will be beep
and the indicator light will be ON. The bulbs for flame effect & log-
set will be ON. To adjust the flame intensity, hold down the button
- the flame optics will go higher or lower. Once you have found the
desired setting, release the button. Pressing the button again will
stop the light function.
750 W: Press this button the low heat level. The unit will beep
and the indicator light will be ON. The fireplace heater will give off
low heat. Pressing once again will stop the low heat level func-
tion.
1500 W: Press this button the high heat level. The unit will beep
and the indicator light will be ON. The fireplace heater will give
off high heat. Pressing once again will stop the high heat level
function.
Heat Temperature Control Knob: To adjust the temperature to
your individual requirements, turn the temperature control dial to
the right (clockwise) to increase the desired temperature and to
the left (counter clockwise) for lower temperature.
NOTE: When the O/I switch is turned off, the heater functions will
stop even though the switches may be in the ON position.
OPERATION BY THE REMOTE CONTROL
Plug in your electric fireplace and it will beep once, this means
you have power and your remote is ready to operate your electric
fireplace.
Standby switch. Press this switch once the unit become ener-
gized and you can select the following functions as desired. Press
this switch again. The unit will be OFF and enter standby mode.
Press this button once for flame effect. The unit will be beep
and the indicator light will be ON. The bulbs for flame effect & log-
set will be ON. To adjust the flame intensity, hold down the button
- the flame optics will go higher or lower. Once you have found the
desired setting, release the button. Pressing the button again will
stop the light function.
750W: Press this button for low heat level. The unit will beep, the
pilot light and indicator light will be on. The fireplace heater will
give low heat level. Pressing once again will stop the low heat level
function.
1500W: Press this button for high heat level. The unit will beep,
the pilot light and indicator light w ill be on. The fireplace heater
will give high heat level. Pressing once again will stop the high heat
level function.
REMOTE CONTROL BATTERY REPLACEMENT
Replace with 2 AAA batteries.
WARNING: Do not mix old and new batteries Do not mix
alkaline, standard (Carbon-Zinc), or rechargeable (Nickel
Cadmium) batteries.