Electric fireplace heater i n s t r u c t i o n m a n u a l qcm995p-47ach ndf-70n attention: 1. Find a location for the fireplace heater that is protected from direct sunlight. 2. Do not plug the unit into the power outlet before you read all instructions..
2 when using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, includi ng the following: important safety instructions s a f e t y i n s t r u c t i o n s 1) read all instructions before using this electric fireplace...
3 15) avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord shall be no.16awg minimum size and rated not less than 1875 watts. 16) caution: do not plug this product into a receptacle controlled by ...
4 warning: procedures and techniques if not care- fully followed - will result in damage to the equipment. - will expose the user to the risk of serious injury, illness or death. This electric fireplace heater is for use on 120 volts. The cord has a plug as shown at a in illustration below. An adapt...
5 a s s e m b l y assembly instructions parts list: fireplace insert .................................................1 a) top panel ..................................................1 b) base panel ...............................................1 c) front upper panel ..................................
6 mantel and insert assembly: warning: make sure the fireplace insert controls are in the off position and the insert is not plugged in. Caution: place a piece of cardboard or protective sheet on the floor in order to avoid scratching the decorative surface of your mantel during assembly. Please do ...
7 step 4: attach panels f, h and k to base [b] with 2 kd screws. Attach panels g, j and l to base [b] with 2 kd screws. See fig. D. Fig. D step 5: attach front lower panel [e] to left small panel [h] and right small panel [j] with 2 kd screws. See fig e. Fig. E step 6: attach front upper panel [c] a...
8 fireplace insert installation the fireplace insert can be installed after the mantel has been fully assembled. Warning: make sure the fireplace insert controls are in the ‘off’ position and the unit is not plugged in. Step 1: place the insert in the back of the mantel on the floor. Carefully lift ...
9 operation by the control panel the controls are located behind the grill below the front glass and can be accessed by pulling the grill from the top, forward and down. On/off: press this button for main power and flame effect. The indicator light will turn on. See below for other control switches....
10 replacing the light bulbs step 1: remove 4 screws on the back of fireplace and remove the rear cover of the unit. Step 2: you will find 1 x 40w type b-10 bulbs under log-set bed. Step 3: turn counter clockwise to take out the burnt out bulb, then screw in a new bulb in the clockwise direction. St...
11 fig. B 2. Drill the holes with diameter 3/4 inches (10 mm) and depth 3/4 inches (10mm) on the mantel. Each plastic connector needs 3 holes. See fig. C. Fig. C fig. D 3. Gently install the kd nuts into the drilled-holes with hammer as shown in fig. D. 4. Attach the plastic connector and lock in pl...
12 fig. G fig. H 3. Attach the small l-bracket and lock in place with screws as shown in fig. H cleaning to clean unit first turn off controls on unit and unplug the unit from power source. To clean glass display panel; remove dust with clean dry cloth or to remove finger prints and other marks clea...
