Quality Craft QCM995P-47ACH Instruction Manual - page 6
6
MANTEL AND INSERT
ASSEMBLY:
WARNING: Make sure the fireplace INSERT
controls are in the OFF position and the
INSERT is NOT plugged in.
CAUTION: Place a piece of cardboard or
protective sheet on the floor in order to avoid
scratching the decorative surface of your
mantel during assembly. Please DO NOT
fully tighten the KD screws until all panels
are assembled.
NOTE: If the KD screw(s) do not fit during
assembly, loosen the 2 screws to adjust
the Plastic Connector until the PANEL/ KD
SCREWS are able to be installed. Tighten all
KD screws once all panels assembled.
Step 1: Attach 10 Plastic Connectors [X] to
Left Side Panel [K] and Right Side Panel [L]
with 20 KD screws (2 screws for each plastic
connector). Attach 4 Plastic Connectors [X] to
Front Upper Panel [C] with 6 KD screws. At-
tach Front Upper Panel [C] and Front Middle
Panel [D] together with 2 KD screws. See
Fig. A.
fig. A
Step 2: Attach Left Front Panel [F] to Right
Side Panel [K] with 3 KD screws. Attach Right
Front Panel [G] to Right Side Panel [L] with 3
KD screws. See fig B.
fig. B
Step 3: Attach 2 PLASTIC CONNECTORS [X] to
LEFT and RIGHT SMALL PANELS
(H and J) (2 screws on each connector).
Attach LEFT SMALL PANEL (H) to LEFT
FRONT PANEL (F) with 2 KD SCREWS. Attach
RIGHT SMALL PANEL (J) to RIGHT FRONT
PANEL (G) with 2 KD SCREWS. See Fig. C
fig. C
A S S E M B L Y