QUAN SHENG TG-UV2PLUS User Manual - page 12
16
17
1. On standby mode, press + to enter, the LCD displays as picture 5.
2. Press or to choose VOX level, which has levels (OFF~9), OFF.
(1) is the lowest level, (9) is the highest level.
3. After setting is finished,press to confirm, then the system will
automatically return to standby mode. ( LCD displays as picture 6).
1. On frequency mode, press + , the LCD displays as picture 4.
2. By operating it repeatedly, you may select frequency deviation mode between (+) (-).
Frequency deviation mode.
a. If trasmitting frequency is higher than receiving frequency , it is normal direction (+).
b. If trasmitting frequency is lower than receiving frequency, it is inverse direction (-).
c. Signal without (+) (-) means it has no setting.
3. After setting, the system will confirm automatically
F
4
RPT
M
06
440.025
00
M
01
46.025
00
H
Picture 4
+
Fequency Deviation Setting (+/-)-----Menu 4
This function is a way used with repeater or other working stations.
NOTICE
Select correct frequency deviation direction according to the station you use.
This function is invalid under channel status.
F
5
VOX
MR/
VFO
vox 3
M
01
46.025
00
H
Picture 5
H
M
06
440.025
00
M
01
46.025
00
VOX
VOX Function-----Menu 5
When this function is on, the system will inspect your talking to the microphone and
then it will automatically shift to transmitting mode without manual operation.
This function is more convenient for headset users.
Picture 6
1. On frequency mode, press + to enter, the LCD displays "RC.***" .
( as picture7).
2. Code scanning is started.
3. Press to change the code mode, after searching the code, it would stop
automatically.
Code mode: CTCSS: 67.0-254.1 (CTCSS)
DCS: NO23-N754 (Normal DCS)
DCS: I023-1754 (Inverse DCS)
4. After setting, press to confirm. Press PTT to return to standby mode.
NOTICE
The higher the level is , the higher the sensitivity of microphone is.
When scanning, FM radio or dual watch, this function is invalid.
F
6
SEAR
BAND
Rc.670
M
01
46.025
00
H
Picture 7
MR/
VFO
Research CTCSS/DCS Code (RC)-----Menu 6
Using this function may search and store the CTCSS/DCS code other radios
send. When other stationshas the same frequency but different CTCSS/DCS.
BAND
F
MR/
VFO
If one of the code modes doesn't search code, press to change the code
mode and search again.
If you want to store to channel mode, press + (see Menu 26).
Reverse (REV)-----Menu 7
NOTICE
When using this function, the receiving and transmitting frequency will reverse,
together with the CTCSS/DCS set.