Quantum 3U Quick Start Manual - page 2
2
Connecting the Drive Interface and Power Cables
LTO-5 Full-Height Tape Drive
Power Requirements
Power requirements for the 3U Rackmount enclosure are as follows:
• 100 to 240 Volts AC/2 to 4 Amps
• 47 to 63 Hz
Connecting the Drive Interface and Power Cables
1 Shut down and turn off the host server system.
2 Turn off all attached accessory devices, such as printers and other SCSI devices.
3 On the back panel of a serial-attached SCSI (SAS) 3U Rackmount enclosure (see
Figure 1
):
a Connect one end of the supplied external SAS interface cable to the external SAS
interface connector on the same side of the enclosure as the installed tape drive
(see
Figure 1
).
b Connect the other end of the external SAS interface cable to the SAS connector
on the host server.
Figure 1 SAS Interface
Connectors
SAS connectors
4 Connect the supplied AC power cable to the AC power connector on the back panel
of the 3U Rackmount enclosure (see
Figure 2
).
Figure 2 AC Power Connector
AC power connector