Quantum 3U Quick Start Manual - page 7
Installing a Second Tape Drive or Replacing a Tape Drive
7
LTO-5 Full-Height Tape Drive
Figure 7 Removing the Tape
Drive
2 Remove the screws securing the mounting drive tray to the tape drive.
3 Remove the failed tape drive from the drive tray.
4 Position the new tape drive in the drive tray and align mounting holes with the holes
in the drive tray.
Caution: If you are installing a half-height tape drive, using screws other than
the Phillips screws labeled as General Mounting Screws can damage
the tape drive.
Do not use screws other than the General Mounting Screws to secure
the internal LTO-5 Half-Height Tape Drive.
5 Secure the drive using two screws on each side of the tape drive.
6 Install the tape drive tray into the 3U enclosure (see
Figure 8
):
a Place the drive tray in the enclosure at an angle and then lay it flat.
b Slide the drive toward the front of the enclosure.
Note: Ensure that the cut outs on the drive tray line up with the tabs on the
enclosure.