Quantum 3U Quick Start Manual - page 5
Installing a Second Tape Drive or Replacing a Tape Drive
5
LTO-5 Full-Height Tape Drive
2 Loosen the thumbscrew.
3 Remove the drive tray (see
Figure 5
):
a Push the drive tray toward the rear of the 3U enclosure.
b Pull the drive tray up and out at an angle.
Figure 5 Removing the Drive
Blank
Drive tray
Drive tray
Drive blanks
Drive blanks
4 Remove the drive blanks from the front of the drive tray.
5 Position the tape drive in the drive tray and align mounting holes with the holes in
the drive tray.
Caution: If you are installing a half-height tape drive, using screws other than
the Phillips screws labeled as General Mounting Screws can damage
the tape drive.
Do not use screws other than the General Mounting Screws to secure
the internal LTO-5 Half-Height Tape Drive.
6 Secure the drive using two screws on each side of the tape drive.
7 Install the tape drive tray into the 3U enclosure (see
Figure 6
):
a Place the drive tray in the enclosure at an angle and then lay it flat.
b Slide the drive toward the front of the enclosure.
Note: Ensure that the cut outs on the drive tray line up with the tabs on the
enclosure.