Quantum ATL 7100 Operator's Manual - page 46
Chapter 2 Operating the Library
Using the Control Panel Menus
30
Quantum|ATL 7100 Series Library Operator’s Guide
8
Exit the menu mode.
Setting a Tape
Drive SCSI
Address
2
The SCSI Address/ Drive function is used to set the SCSI address
of tape drives in the library. The library ships with the tape drives
configured as shown in
.
Table 2 Default Tape
Drive SCSI Address
To change the SCSI addresses of the drives in the library:
1
Enter the menu mode.
Note:
After changing the SCSI address of the library, one of
two things must happen to set the new SCSI ID: the
host controller must issue a “SCSI Bus Reset,” or the
library must be powered off and on again.
SCSI Address
Drive Number
Physical Location
1
0
top drive
2
1
second drive
3
2
third drive
4
3
fourth drive
5
4
fifth drive
6
5
sixth drive
1 (second bus)
6
bottom drive
Note:
SCSI address 7 is typically reserved for the host
controller.