Quantum ATL 7100 Operator's Manual - page 49
Chapter 2 Operating the Library
Using the Control Panel Menus
Quantum|ATL 7100 Series Library Operator’s Guide
33
Defining the
Library Power-Up
State
2
The condition of the library after power-up, self-tests and
initialization can be defined as either On-line or standby (Off-line).
The default is On-line.
To change the power-up state:
1
Enter the menu mode.
2
Press the
SELECT
button to choose the Configuration menu
and verify the following is displayed in the SDA:
3
Use the
↓
button to bypass the Inquiry menu and verify the
following is displayed in the SDA:
4
Press the
SELECT
button to choose the Power-Up State menu
and verify the following is displayed in the SDA:
5
Use the
↓
button to bypass the System On-line option and
verify the following is displayed in the SDA:
6
With the desired option displayed on line 2, press the
SELECT
button.
7
Exit the menu mode.
Menu:Configuration
Inquiry
Menu:Configuration
Power-Up State
Menu:Power-Up State
On-line
Note:
System On-line is the default. If you want to change
the power-up state to standby, proceed to step 5.
Otherwise, exit the menu mode.
Menu:Power-Up State
Standby