Quantum ATL 7100 Operator's Manual - page 54
Chapter 2 Operating the Library
Using the Control Panel Menus
38
Quantum|ATL 7100 Series Library Operator’s Guide
To change the SDA language:
1
Enter the menu mode.
2
Press the SELECT button to choose the Configuration menu.
3
Verify the following is displayed in the SDA:
4
Use the
↓
button to bypass the Inquiry, SCSI Address, Power-
Up State, Auto Clean, Retries and Auto Load sub-menus and
verify the following is displayed in the SDA:
5
With Language displayed on line 2 of the SDA, press the
SELECT button and verify the following is displayed in the
SDA:
6
Use the
↑
and
↓
buttons to navigate to the desired language.
7
With the desired language displayed on line 2, press the
SELECT button.
8
Exit the menu mode.
Adjusting the
Status Display
Area Contrast
2
To adjust the status display area contrast:
1
Enter the menu mode.
2
Press the SELECT button to choose the Configuration menu.
3
Verify the following is displayed in the SDA:
Menu:Configurati
Inquiry
Menu:Configurati
Language
Menu:Language
English
Menu:Configurati
Inquiry