Quantum ATL 7100 Operator's Manual - page 48
Chapter 2 Operating the Library
Using the Control Panel Menus
32
Quantum|ATL 7100 Series Library Operator’s Guide
Table 3 Tape Drive
Locations
7
With the proper drive number displayed on line 2, press the
SELECT
button and verify the following is displayed in the
SDA:
8
Use the
↑
and
↓
buttons to navigate to the SCSI ID for the
selected drive.
9
With the proper SCSI ID displayed on line 2, press
SELECT
.
10
Exit
the menu mode.
11
After changing the SCSI address of the drives, do one of the
following to set the new SCSI ID:
•
Run the Reset Drives command from the Diagnostic
Software Package.
•
Issue a “SCSI Bus Reset” from the host controller.
•
Power the library off and on again.
Tape Drive Number
Physical Location
Drive 0
top drive
Drive 1
second drive
Drive 2
third drive
Drive 3
fourth drive
Drive 4
fifth drive
Drive 5
sixth drive
Drive 6
bottom drive
Menu:Drive 0
SCSI ID 0
Caution:
If you turn the library power off and then on
again, be sure to leave the power off for at least
15 seconds before turning power back on.