Quantum QP2125 Instruction Manual - page 5
amperes
Quantum QP2000 Series Power Amplifiers
PAGE 5
Connecting The Unit
1
Audio from pre-amp
mixer ( balanced line )
XLR
connections
Duty Amplifier Unit
Duty Amplifier Unit
Standby Amplifier
24V DC
Fr Battery
Bank
100V Line Out
To Zone Selector
100V
Out
Standby Unit
100V Line Out
Standby 100V
Line Links
note on the link
connections for
standby amplifier
Note 1 :
Loop the audio signal to a maximum of 6 to avoid signal distortion. In case that more amplifiers are required in
the system, use a signal distribution amplifier.
Note 2 :
Always ensure cable size, particularly the incoming cable from battery is sufficient enough to cater for the load
during battery takeover when the mains failed. As a rule of thumb, a 2.5mm cable shall not be linked to more
than 6 power packs.
Note 3 :
AFS only applies to 100V line output. Should you decide to turn of the feature utilising the internal changeover
relay, always connect the output at 100V line terminals. At any one time, never use different outputs simultane-
ously.
Note 4 :
The amplifier that need to be accorded top priority for changeover should be connected first to the standby
amplifier output. If the changeover occurs at the first unit, the remaining shall not be provided with back up
output.
In order for changeover to take place, AFS feature must be turned on.
2
3
4
A connection diagram for basic installation with single input source from pre-amplifier mixer.