Quantum QP2125 Instruction Manual - page 8
PAGE 8
amperes electronics
Setting The Unit
Firmware : V02.00
Initialize ...
Upon powering up the unit, the
display shall appear as shown,
Initialising and into ready mode.
QP2000 ( 2 )
VOL:20 T:26
Displaying firmware version of
the unit
Showing unit address in bracket,
volume level and temperature
To begin setting, press the MENU button.
Use Next and Prev button to shift around.
UP
M ENU
DO W N
1.0 CHANNEL SETTING
Menus available are for :
1. Channel setting
2. Cascading / setting unit address
3. Fan and AFS setting
4. Factory reset
1. CH. SETTING
1.1 VOLUME :
18
1.1 VOLUME :
*
18
1.1 VOLUME :
20
Press MENU and
menu 1 Channel
setting will appear.
Use UP and DOWN button to select
sub menu
To select sub menu
for volume adjust-
ment, select 1.1
Press MENU button
and an asterisk
would appear
Use UP and DOWN
key to adjust
volume level
To confirm the
value, press MENU
button.
1.2 BASS :
+2
1.2 BASS :
*
+2
1.2 BASS :
*
+6
Use UP / DOWN
button to select the
next sub menu
To select sub menu
for bass level, press
MENU and asterisk
would appear
Use UP and DOWN
key to adjust
volume level
To confirm the
value, press MENU
button.
1.2 BASS :
+6
1.3 TREBLE :
+2
1.3 TREBLE :
*
+2
1.3 TREBLE :
*
+6
Use UP / DOWN button
to select the next sub
menu
To select sub menu for
treble level, press MENU
and asterisk would
appear
Use UP and DOWN key
to adjust volume level
To confirm the value,
press MENU button.
1.3 TREBLE :
+6
1.4 BACK
Use UP / DOWN button
to return to Sub Menu 1.
Select Sub Menu 1.4
and press MENU.
1. CH. SETTING