QUATTRO EMS GM380E Operation Manual - page 9
9-Volt DC Adaptor
Because the current consumption is large for the device, it is recommended to use
the 9V DC adaptor. Plug the DC plug into the DC jack of the unit, and plug the
adaptor into your 110V wall outlet. Please be sure you are using the correct
polarity of DC plug.
CLEANING FOR YOUR DEVICE
Your device may be cleaned by wiping gently with a damp cloth moistened with
mild soap and water. Never immerse the device in water or other liquids.
Wipe lead wires with a damp cloth as above if they become soiled.
To properly store the device an extended period of time, remove the battery from
the unit. Put the unit and accessories in the carrying case and store in a cool dry
location.
TROUBLESHOOTING
If the device does not function properly:
1. Make sure the battery is properly installed or replace battery. Be sure to
observe proper polarity markings when replacing the battery. If the low battery
mark light is on the LCD pane when the unit is turned on, replace the battery
and check again.
2. If the intensity has been adjusted and there is no stimulation, check that the
leas wires are properly connected and the electrodes are in place. If the unit
appears to be functioning and no stimulation, the lead wires or electrodes may
need to be replaced.
3. If the battery appears to be charged and the unit is not functioning,
turn both
intensity Control Knobs of each unit to the OFF position (counter
clockwise) for about 7 sec.
Then gradually turn the intensity Control Knob
clockwise until stimulation is felt. If the device is still not working, turn off your
device and contact your distributor.
Note : For any problem, please contact your distributor. Do not try to repair
this device by yourself.
-
7
-