Quick MILL Achille 0996 Instruction Manual - page 4
Quick Mill
Achille
4
5. CONNECTION TO THE MAIN POWER NETWORK
- The connection to the main power network must be done by qualified personnel.
- The system must be installed in conformity with the current laws and it must be grounded.
The machine comes with a power cord with plug; the ends of the cord must be connected to a double
pole breaker with minimum contact opening 3 mm with leakage current protection of 30mA.
Make sure that the water supply line is connected to a drinking water supply system with operating
pressure between 14 and 87 psi. If the water supply system has pressures over 87 psi, use a pressure
regulator. Install a water shut-off valve upstream of the machine connection.
5.1 Drain connection
Connect the rubber discharge tube, with inner diameter of
1/2’’ to the connector set up on the machine’s
overflow and to a siphon discharge that is open or that can be inspected set up beforehand.
5.2 WATER SUPPLY
The machine is set up to be connected to the water supply system. A softening system is recommended.
Once the machine has been connected, use the water supply selection switch (Figure 2) to select the type of
supply. Tanica= Tank Rete= Water Line or ”Network”
6
– USING THE MACHINE
6.1 Turning on the machine and filling the boiler with water
Move the two position switch to the ON position. Turn the machine power-on (Fig. 1 ref. 1) switch to
position 1 and make sure that the indicator light comes on. Wait until the boiler is filled and then wait until
the boiler pressure gauge indicates a pressure between 1 and 1.2 bar before using the machine.
6.2 Heating
To bring the machine to the correct temperature, and ensure properly operating, open the steam and
water valve and discharge 2 or 3 times into the drain tray. If the red indicator light is on it means that the
heating element is on. The pressure indicated by the boiler pressure gauge should be between 1 and 1.2
bar. (Fig. 1 ref. 12)
6.3 Preparing the coffee
Remove the portafilter from the dispensing group. Fill the portafilter with ground coffee; tamp the coffee
being sure not to dirty the edge of the portafilter.
1. Re-hook the portafilter in its seat.
2. Lower the group lever to start dispensing.
3. Release the group lever, re-accompanying it to the rest position, to stop dispensing when the desired
dose has been reached.
Warning: to avoid possible damage, the group lever, being subjected to water pressure
and to the force exercised by the return springs, must always be re-accompanied to the
rest position.
Figure 2