Quidway S5012G Operation Manual - page 12
Operation Manual - Port
Quidway S5000 Series Ethernet Switches
Chapter 2 Link Aggregation Configuration
2-2
2.3 Display and Debug Link Aggregation
After the above configuration, execute display command in any view to display the
running of the link aggregation configuration, and to verify the effect of the
configuration.
Table 2-2 Display the information of the link aggregation
Operation
Command
Display the information of the link aggregation
display link-aggregation [ master_port_num ]
2.4 Link Aggregation Configuration Example
I. Networking requirements
The following example uses the link aggregation commands to aggregate several ports
and implement the outgoing/incoming payload balance among all the member ports.
The link aggregation is typically used for Trunk ports. Since the Trunk port allows
frames from several VLANs to pass through, the heavy traffic needs balancing among
all the ports.
Ethernet Switch (Switch A) is connected to the Ethernet Switch (Switch B) in the
upstream via the aggregation of three ports, GigabitEthernet0/1 through
GigabitEthernet0/3.
II. Networking diagram
Link aggregation
Switch B
Switch A
Switch C
Figure 2-1 Configure link aggregation
III. Configuration procedure
The following configurations are used for Switch A, please configure Switch B in the
similar way to activate aggregation.