Quidway S5012G Operation Manual - page 13
Operation Manual - Port
Quidway S5000 Series Ethernet Switches
Chapter 2 Link Aggregation Configuration
2-3
# Aggregate GigabitEthernet0/1 through GigabitEthernet0/3.
[Quidway] link-aggregation gigabitethernet0/1 to gigabitethernet0/3 both
# Display the information of the link aggregation.
[Quidway] display link-aggregation gigabitethernet0/1
Master port: GigabitEthernet0/1
Other sub-ports:
GigabitEthernet0/2
GigabitEthernet0/3
Mode: both
2.5 Ethernet Link Aggregation Troubleshooting
Fault: You might see the prompt of configuration failure when configuring link
aggregation.
Troubleshooting:
z
Check the input parameter and see whether the starting number of Ethernet port is
smaller than the end number. If yes, take the next step.
z
Check whether the Ethernet ports that are in the configured range belong to any
other existing link aggregations. If not, take the next step.
z
Check whether the ports to be aggregated operate in the same speed and full
duplex mode. If yes, take the next step.
z
Check if there are no more than eight ports in one group.
z
If correct, configure the link aggregation again.