Rabbit RabbitCore RCM4400W Product Manual - page 14
8
RabbitCore RCM4400W
1.4.3 Japan Labeling
1.4.4 Europe
The marking shall include as a minimum:
•
the name of the manufacturer or his trademark;
•
the type designation;
•
equipment classification, (see below).
NOTE: Manufacturers are recommended to declare the classification of their devices in
accordance with Table 2 and EN 300 440-2 [5] clause 4.2, as relevant. In particular,
where an SRD that may have inherent safety of human life implications, manufacturers
and users should pay particular attention to the potential for interference from other
systems operating in the same or adjacent bands.
Regulatory Marking
The equipment shall be marked, where applicable, in accordance with CEPT/ERC Recom-
mendation 70-03 or Directive 1999/5/EC, whichever is applicable. Where this is not appli-
cable, the equipment shall be marked in accordance with the National Regulatory
requirements.
The logo mark diameter must be 5 mm or bigger.
If the equipment is 100 cm
3
or smaller in volume, the minimum size of
the logo mark is 3 mm.
Receiver
Class
Risk Assessment of Receiver Performance
1
Highly reliable SRD communication media, e.g., serving human life
inherent systems (may result in a physical risk to a person).
2
Medium reliable SRD communication media, e.g., causing
Inconvenience to persons that cannot be overcome by other means.
3
Standard reliable SRD communication media,e.g., inconvenience to
persons that can simply be overcome by other means.
R
Model Name Use Your Company Model
ID Number 003WW071090000
Company Name Use Your Company Name