Rabbit RabbitCore RCM4400W Product Manual - page 48

40

RabbitCore RCM4400W

A program “runs” in either mode, but can only be downloaded and debugged when the 

RCM4400W is in the Program Mode.

Refer to the 

Rabbit 4000 Microprocessor User’s Manual

 for more information on the pro-

gramming port.

4.3.2  Standalone Operation of the RCM4400W

Once the RCM4400W has been programmed successfully, remove the programming cable 

from the programming connector and reset the RCM4400W. The RCM4400W may be 

reset by cycling, the power off/on or by pressing the 

RESET

 button on the Prototyping 

Board. The RCM4400W module may now be removed from the Prototyping Board for 

end-use installation.

CAUTION: Power to the Prototyping Board or other boards should be disconnected 

when removing or installing your RCM4400W module to protect against inadvertent 

shorts across the pins or damage to the RCM4400W if the pins are not plugged in cor-

rectly. Do not reapply power until you have verified that the RCM4400W module is 

plugged in correctly.