Racelogic RLVBDSP04 Instruction Manual - Oled Display Manual
- 7 -
12/06/09
OLED Display Manual
Predictive Lap Timing
To use this, the OLED
must have start/finish information set, or an Auto Track-Map element
in the VVB scene.
Until the start line is crossed, the screen will show ‘Waiting For Start Line’.
On the first lap, the OLED will create a reference lap.
The reference lap will be replaced with any subsequent quicker lap time. If you wish to fix this comparison lap time
at any point, then this can be done by pressing the button.
If you wish to save or load a reference lap file, please see the ‘Predictive Lap Timing Settings’ section of this manual.
Reference laps will be reset when either a new Start/Finish is set, or if the ‘Reset Laptiming Data’ option is selected
in the main menu.
The main predictive screen shows a continuously updated bar graph with the +/ - to previous. When a lap is
completed, it will give a final lap time and total time difference to reference lap.
If you achieve a faster time than your reference, a negative time will be shown.
The amount of time shown on the bar graph can be altered in the main menu to 2, 5, 10 or 30 seconds.
Lap Count Display
The lap count screen will display two lap counts. On the left hand side of the screen the total lap count is displayed –
this counter will only be reset by a power cycle of the OLED display. The right hand side of the screen displays the
current laps and will be reset by removal of the logging media from the VBOX unit – SD card or USB stick.