RAD V-RAD User Manual - page 12
V-RAD USER MANUAL
New World Technologies Inc.
Page • 10
V2014.07.03
CORRECT
: Reaction Arm is reacting off the middle of the Reaction Arm’s foot.
Figure 4.1.4-1: Correct Reaction Point
INCORRECT
: Reaction Arm is reacting off the heel of the Reaction Arm. This can cause premature
tool failure.
Figure 4.1.4-2: Incorrect Reaction Point
4.2 Torque Operation
To operate the Torque Cycle:
1. Set the V-RAD to the desired Torque. Refer to Section 3.2 – Torque Chart and
Section 3.3 – Setting Dials.
2. Place the V-RAD on the joint system.
3. Ensure the Forward/Reverse Switch is in the Forward Position.
4. Press and hold the On/Off Trigger.
Note: To stop the Torque Cycle at any time, release the On/Off Trigger.
5. When the V-RAD reaches the Torque, the clutch mechanism will slip. Immediately
release the On/Off Trigger.
CAUTION!
Damage will occur if the clutch is allowed to slip for extended periods of time.
5.0 Errors
Important!
Disassembling or attempting repair will void warranty.
If breakdown, malfunction or error occurs, contact New World Technologies Inc. Technical
Support (refer to Section 6.0 – Contact Us).