RAD V-RAD User Manual - page 5
V-RAD USER MANUAL
New World Technologies Inc.
Page • 3
V2014.07.03
IMPORTANT SAFETY NOTICE
RAD TOOLS ARE SAFE AND RELIABLE. NOT FOLLOWING PRECAUTIONS AND
INSTRUCTIONS OUTLINED HERE CAN RESULT IN INJURY TO THE TOOL,
OPERATOR AND FELLOW WORKERS.
NEW WORLD TECHNOLOGIES INCORPRATED IS NOT RESPONSIBLE FOR ANY
SUCH INJURY.
The intended use of the V-RAD Tool System is for commercial and industrial bolting
applications.
Do not operate the V-RAD Tool System before reading and understanding this user manual
and noting the Safety Notices displayed on the V-RAD Tool System and throughout this
manual.
Only qualified personnel with training in the safe operation of torque tooling and the V-RAD
Tool System should attempt the installation, operation and diagnosis of the V-RAD Tool
System.
The V-RAD Tool System is connected to high voltage power and consists of external
rotating parts. Improper training and use can cause serious or fatal injury.
Do not disassemble or attempt to repair the V-RAD Tool System; doing so will void
warranty. If breakdown, malfunction or damage occurs and the V-RAD Tool System fails to
operate correctly, contact New World Technologies Inc. Technical Support (refer to Section
6.0 – Contact Us).
The V-RAD Tool System should only be used if environmental storage and operation
specifications have been met. Refer to Section 1.2.3 – Environmental Specifications.
Electrical Shock can cause serious or fatal injury. Do not apply power to the V-RAD Tool
System without verifying the Earth Ground.
Ensure all AC Mains Power wiring to the V-RAD comply with all National and Local Electrical
Codes. Improper wiring may result in unsafe conditions for equipment and personnel.
Do not operate the V-RAD Tool System in explosive atmospheres, including, but not limited
to, the presence of flammable liquids, gases or dust. The V-RAD Tool System creates sparks
which could ignite these substances.
Do not expose the V-RAD Tool System to wet conditions. Water in the V-RAD Tool System
will cause damage to the tool and increase the risk of electric shock.
After long durations of use, the V-RAD Tool System will become hot. It is recommended to
use the tool in short intervals and allow for cooling between uses to prevent injury to the
operator or damage to the V-RAD Tool System.
While operating the V-RAD Tool System, always wear safety goggles and keep all body
parts clear of moving parts and the reaction arm contact point.
Never exceed the Maximum Torque of the V-RAD Tool System. Failure to comply, will result
in void warranty.
The V-RAD Tool System has been calibrated by a qualified Calibration Technician.
Calibration must be done by a qualified Calibration Technician. Improper calibration can
cause damage to the tool and joint.