Radenso Pro Series User Manual - Quick Start Up Guide
Quick Start up Guide
To start using your Radenso Pro radar detector follow these easy steps:
1. Slide the windshield mounting bracket into the QuickMount slot at the front of the radar detector
2. Plug the small end of the power cable into the Power Jack of Radenso Pro on the left side of the detector
and connect the large plug with the 12V power socket of your car
3. Press the red button at the large end of the power cable (at the 12 V socket) to turn the power cable on.
The button will light up and indicate if Power is on.
4. Press the Power button (left button on top of unit) for 2 seconds to turn on Radenso Pro
Unit will power up with start up sequence. After a few seconds Radenso Pro will notify you with a Voice
message that Satellite is connected
Adjust the volume level by pressing the Volume buttons „“+“ or “-“ located on the right side of the unit.
Change Default settings:
Radenso Pro is now ready to go. If you want to change any of the default settings of your unit please refer to
the next pages.
Main functions of Radenso Pro
Radenso PRO is one the most powerful detectors in the Industry and is designed to protect the driver from
speeding fines. Radenso Pro communicates with the driver in English language and its main functions are the
detection of microwave radars (X / K / Ka narrow bands), laser guns, red light cameras and fixed speed
cameras (GPS database).
Notifications:
When a radar signal is detected the driver is being alerted by a visual text warning and a voice and tone alert.
The display and voice alert will indicate the received radar band and frequency and the signal strength. A
beeping warning tone will increase its intensity with increasing signal strength. The signal strength has ten
levels. GPS alerts are reported by voice, for example “Speed Camera”.
Page 2